PhalloBoards - An Online Community to Discuss Penile Girth Enhancement

Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1
  • 2

TOPIC: How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection??

How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection?? 11 years 9 months ago #1274449426

I had my fourth and hopefully final procedure yesterday. I flew home afterwords, so It was wrapped for approximately 10 hours before I got home. I gotta tell you, that the immediate results so far seem a lot better with doing this. I have been barely masssaging becuase I am finding very few lumps to massage out when I do. A roller sounds interesting as well.

Please Log in or Create an account to join the conversation.

How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection?? 11 years 9 months ago #1274449454

I spoke to Wade a week ago, and he has mentioned brainstorming with Dr. C on ways to reduce/mitigate Nodule formation in patients. He also said that it was nearly impossible to predict, because the nodules form after the procedure, and it\'s hard to monitor how effectively patients are following post-op protocol. And even then, is that enough?This roller idea could prove very beneficial, I\'ll run it by them next time we chat.

Please Log in or Create an account to join the conversation.

How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection?? 11 years 9 months ago #1274449584

The most experienced doctors in Glans and shaft girth enhancement by using only filler injection and who published papers about that (>10 years ago) and also who invented the \"Lipen-10\" filler are :- Dr. Je Jong kim and Du Geon Moon .

onlinelibrary.wiley.com/doi/10.1111/j.17...010.01748.x/abstract

phalloboards.websitetoolbox.com/post/quo...ion-5710648?trail=15 (( post 1))

www.ncbi.nlm.nih.gov/pubmed/14671664

So they started with a temporary filler for shaft girth enhancement at the beginning then they shifted and invented a more permanenet filler \"Lipen-10\".

What I read about them they started to use these penile filler injection before 2003.

So i.e. they have a great experience in penile filler augmentation more than others and if they advised other doctors to use a roller to homogenize the injected temporary filler in its injected area to get the best esthetic result (I.e. I am sure before \"this technique post-injection\" they did not get a good esthetic results i.e irregularities or even lumps) so they must have modified their post-injection\'s instructions .

So imo if it is important to use it directly after a penile temporary filler (from their experience) ---> i.e. definitely it will be also more important to use it after a penile permanent filler.


I have sent an e-mail to Dr. Du Geon Moon asking him about this technique in comparison with massaging or wrapping ??

Please Log in or Create an account to join the conversation.

How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection?? 11 years 9 months ago #1274449625

Wouldn\'t a bandage be more effective with Artefil, than Metacril or Linea Safe? Surely it\'s more risky to apply any sort of pressure to a filler that sets quickly. If the bandage is too tight in one place, but sets quickly it could cause a dent. You could apply the bandage too tightly in one area and by the time you get off your flight the PMMA could be hard to manipulate.

Please Log in or Create an account to join the conversation.

How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection?? 11 years 9 months ago #1274471732

Hi I have received an e-mail from Dr. Du Geon Moon (that was very kind of him) he sent me his full article with pictures showing how he uses a roller directly post-injection to even the injected Dermal Filler and he still uses this technique till now,after that he uses an elastic bandage.I will try to ask SO to post it here for me.

Please Log in or Create an account to join the conversation.

How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection?? 11 years 9 months ago #1274471969

It looks to me from the pic. I have seen the usage of a roller has more advantage than massaging directly post-injection before the beginning of the edema, in this technique imo the force over the injected filler is equally distributed and it smoothens any major or minor bulges and it looks much better than the unequal forces from our hand during massaging , then directly an elastic bandage should be used and esp at nighttime.

Please Log in or Create an account to join the conversation.

How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection?? 11 years 9 months ago #1274475548

After the Cialis, and my Dick looking huge, I have the extreme urge to rub one off, and that type of manipulation is hard to resist, but the effect of, as smartman describes, \"unequal forces,\" can force the product into uneven clumps, maybe even if careful.

Please Log in or Create an account to join the conversation.

How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection?? 11 years 9 months ago #1274475654

I\'ll post what Smartman was referring to once our Uploading system is running normally again (later this week).

Please Log in or Create an account to join the conversation.

How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection?? 11 years 9 months ago #1274476299

I saw these little cylindrical metal rollers that are used to distribute the injected product in the face..is this the same thing you guys talking about?

Please Log in or Create an account to join the conversation.

How to get a better esthetic outcome (less lumps and irregularities) after penile PMMA injection?? 11 years 9 months ago #1274645709

jlmb wrote: I talked to Dr. C and Wade about the roller idea and they said they use that on the face because there is bone underneath. They said the roller helps with irregularities against the facial bone structure as it has a base, but you wouldn\'t do it with the penis.



@jlmb


Thanks for checking with Dr C and Wade about this. There is still progress to be made on the post op uniformity of PMMA and it would be good to explore options further?


Also, has anyone already asked them if they\'d be disposed to experimenting with Silikon1000 for corrective purposes? Those of us who have significant voids between PMMA induced collagen growth might stand to benefit from this, and I for one would be willing to try just about anything plausible and providing hope to uniformize the final result with a smooth rather than a chunky surface...


Anyone here who is in touch with them and can bring this up, thanks for letting us know.


HC

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
  • 2