TOPIC: What amount of NewPlastic will get me around 6'' starting from 5.3''?

Hi guys,

I have recently started posting on here but have been reading all the info I can from you guys for about half a year now. I have a goal in mind and I want some info on how to achieve it. Before I start, I will like to say that I am 99.9% sure that I am going to go through with visiting Dr. C for the Girth enhancement procedure. I have spoken to Ian as well and have riddled him with questions and such and the answers have assured me that this is what I want. So I really want the discussion/answers to be focused on helping me achieve my goal rather than alternatives or trying to talk me out of it.

So first I will start with my details (that matter):Age - 24
FG - 4.6\'\' (all around, I\'m lucky!)
EG - 5.3\'\'

My goal is to be a little below 6\'\' in Girth but honestly being 6\'\' or a cm more won\'t hurt me. I really just want to stress the fact that I do not want to go above 6\'\' too much at all as from what I have read, that seems to be the size limit for maximum fun without having pussy casualties. Also, I want the aesthetics to be as natural looking as possible with minimum risks of nodules or other complications related.

D. C has said that he normally recommends about 30% injected as that will get you a good .75 to 1\'\' give or take some cm. I definitely right now do not have any desire of being 6.3\'\'. So if I do the math, if 30% gives you 1\'\'. 20% should give you about .7\'\' and 10% should give you around .4\'\'. In an ideal world that would mean that I should request about 15% just to be on the safe side. That should put me at an EG of about 6\'\' but more than likely about 5.8\'\' or 5.9\'\'.

Does this sound right? Around what amount should I be looking for to have the increase go as unnoticed visually as possible but still reach my goal or at least around my goal?

Hi, PMMA is only injected at 10% or 30% concentrations. 30% is usually injected at the base for bigger Girth and 10% is usually used for the neck of the penis up to the glans. You really do not have to worry about gaining an entire Inch of Girth from one round of 30% as that would be an extremely rare amount of Girth to gain from one round. When you are getting the procedure just stress that your primary concern is aesthetics and Dr. C will take a conservative approach and limit his use of 30%. Hope I was helpful. Good luck.

You likely won\'t gain anywhere near .7+, if so that would absolutely be max. I think a lot depends on your length and amount of PMMA/length. I think a +.5 for a first round is a stellar outcome. However, this is my experience and reading a lot of case reports. I have only gone 10 and 20%.

Go 10%. Sounds like one round of about 20cc of 10% will give you your goals but not gaurented as everyone reacts differently. At 24 you are younger than most who do this which is good from a collegen piont of view. Younger you are the more likely you will grow per cc and concentration.

Are you uncut btw? As asthethics are very important be aware of the problems uncut guys get. Also are you more about Grower or shower? Basically movement and PMMA don\'t mix well. A cut shower with large glans is the ideal patient when aesthetics are important.

Southdub wrote: Go 10%. Sounds like one round of about 20cc of 10% will give you your goals but not gaurented as everyone reacts differently. At 24 you are younger than most who do this which is good from a collegen piont of view. Younger you are the more likely you will grow per cc and concentration. Are you uncut btw? As asthethics are very important be aware of the problems uncut guys get. Also are you more about Grower or shower? Basically movement and PMMA don\'t mix well. A cut shower with large glans is the ideal patient when aesthetics are important.

I read a story about someone who went in for 10% and he had virtually no gains. Then again someone else I believe on that same thread got the same amount and had expected gains. TBH I wonder if that guys after care was slacking. I believe it was 93East. I am uncut and though I may be biased, aesthetically my penis locks like it could be a model as far as characteristics of it being straight, not curved, circumsized and such. I would rather be a Grower, if that means gaining EG. But I still want it to look at least the same version of my current but thicker. So are you saying sex and the collagen don\'t go well together experience wise? Is this from experience? As far as being younger thats great! I hope just 10% will be enough to reach my gains.

If you are uncut, I think it is best to go with 10% and not too much. The aesthetics of PMMA are different in cut and uncut. Just something to keep in mind.
And you are right that one guy can get PMMA and have incredible growth while the next guy gets very little. And the same thing can happen to the same person on different rounds.

But if you want to maintain your model Dick aesthetics, it is conservative 10%, in my opinion.